1. Wiring the power supply
1.1. Wiring the power supply for the VPFlowScope M
 |  |
| 1. Prepare the power supply: 2. Select the right socket type for your country. Place it on the power supply. | 3. Tighten by sliding it. |
 |  |
| 4. Screw off the black protection cap from the M12 5-pin connector from the VPFlowScope M Transmitter. | Before going into the field: 5. If not used, always put the protection cap back before going into the field to protect against e.g. dirt. |
 |  |
| 6. Insert M12 connector of power supply in corresponding M12 connector. | 7. Note the guidance pin! Fixate by screwing the ring. |
 |  |
| 8. Plug the power supply into the power outlet. | 9. Final assembly. When the Transmitter of the VPFlowScope M lights up. You are good to go! |
1.2 Wiring the power supply for the VPFlowScope
The pictures are a visual aid, in order to give a clear indication of what needs to happen at each step so as to avoid confusion.
| |
| 1. Prepare the power supply: 2. Select the right socket type for your country. Place it on the power supply. | 3. Tighten by sliding it. |
 |  |
| 4. Connect the power supply to the JB5 converter. | 5. Insert M12 connector of the JB5 kit in corresponding M12 connector. |
| |
| 6. Notice the guidance pin! Fixate by screwing the ring. | 7. Plug the power supply into the power outlet. |
 | |
| 8. Final assembly. When the Transmitter of the VPFlowScope M lights up and you see this symbol in the upper-left corner: you are good to go! |